If
you have to put a trim on the machine it can go straight through the
column, as in case with this machine. In such case, you have to put a
screw straight through the column. If you notice you could see some
wires going down the column. So there is a possibility of damaging
those in the process. So the tip here is to make sure that the hole
is clear before you put the screws in. When you tighten the screws in
and you start feeling
that they are tight you need to stop tightening them more. Because
if you overdo you may break the plastic. So put one screw on the top
and one on the bottom and that’s it.
For further information, visit our website.
For further information, visit our website.
No comments:
Post a Comment