Today
I am going to tell you how to fix a wobbling cross trainer. So I’ve
just built this cross trainer and I can actually see that something’s
not right. Something is loose somewhere. There’s a lot of noise and
it doesn’t feel right at all. I think that the problem is with feet
and I am going to show you how to adjust them. I’m going to remove
foot here. It consists of a Teflon washer at the bottom and this is a
locking nut. It goes into the hole here and then you can position the
height of the feet by scrolling it. When
you put it into the right position all you have to do is to tighten
the locking nut so it looks nice and solid. All of the feet have to
be at the same height, so you have to check it. When they are all at
the same level, you can tip the machine back over and check the level
once again. I am quite happy with the work I did; however, if you
want you can make small adjustments right at this position. The point
here is that the machine should be nice and level. There should not
be any wobbling at all once when you are using the machine. So I’m
happy with that and we’ll just lock that up so and then retest the
machine and we should be good to go.
For further information, visit our website.
For further information, visit our website.
No comments:
Post a Comment