Monday, 7 March 2022

Kettler D6D05 Motor installation & Error 91 / 92 on Kettler

The original motor D6D05 is not manufactured anymore, however it is possible to install a replacement that you can find here: https://www.partsfortreadmill.com/kettler-d6d05.html

Motor compartment view after the installation
In this photo we can see the motor compartment view after the installation

Let's see now a possible problem with the installation: Error 91 or 92. On most of Kettler treadmills these errors are related to speed sensor.

Error 92 91 on Kettler treadmill


After carefully looking the installation it appear the sensor has not been properly centered


Consequently the treadmill starts and then stops



By better fitting the sensor, the problem will be solved




Saturday, 5 March 2022

Donation

All the people working in our company have been very affected by the dramatic emergency situation that has occurred in Ukraine in the face of the invasion by the Russian army.

We can only join the chorus of all those who deplore the use of force and who demand the highest economic sanctions against the invading state, even if these were to the detriment of the economy.

We have frozen the ability to display our sales sites to all customers located in Russia and Belarus.

To make our words more concrete, we have also made a first donation today to the Polish Red Cross, which is at the forefront of helping refugees arriving from war zones. Our donation of 3000€ today will be doubled by our financial partner Revolut, for a total amount of 6,000€.

We hope that the response of all free people will remain firm in condemning violence without delay, beyond personal gain.



Wednesday, 16 February 2022

Final test after repair Hammer treadmill console

Final test after the repair of an Hammer treadmill console. Original fault: the right part of the keyboard didn't work. 

  To buy this service and for more information, visit www.partsfortreadmill.com

 


 

 

 

Wednesday, 9 February 2022

How to reset Ifit console

 If the console does not boot up properly, or if the console freezes and does not respond, you could reset
the console to the factory default settings.

IMPORTANT


Doing this will erase all custom settings you have made to the console.
Resetting the console requires two people.


First unplug the power cord and press the power switch Next, locate the small reset opening near the USB port on the console. Using a bent paper clip, press and hold the reset button inside the opening, and have a second person plug in the power cord and press the power switch.


Continue holding the reset button until the console turns on When the reset operation is complete, the console will turn off and then turn back on. If it does not, press the power switch off and then on again Once the console turns on, check for firmware updates.

Note: It may take a few minutes for the console to be ready for use.




Wednesday, 26 January 2022

Horizon Fitness, how to make the calibration on their treadmills.

 


Here an official video from Horizon Fitness, how to make the calibration on their treadmills. If you require service or parts, please visit www.partsfortreadmill.com