Wednesday, 24 December 2014

Endex Motor Board Connection to treadmill


2 pin speed sensor motor  [red]
3 pin inclination encoder [blue]
5 and 7 pin connection console (power + commands) [pink]

faston

2 x AC (220V input)
2 M x (m + / m-) current output DC motor
3 x UP / COM / DOWN tilt motor power (220V AC)

Why does treadmill belt go crooked or wear out?

Usually, it is an adjustment problem. After installation (and if used regularly) the belt should be adjusted (see instructions on the blog).

If when adjusting the rear roller you are unable to keep the belt in the centre, check if the front roller is fully aligned.

In some cases, despite the belt being aligned both at the front and behind you notice that it moves through use. In this case, you should check first if the treadmill is well aligned on the floor. If it is, the problem is normally due to the user not walking in the centre or pushing more with one foot, tending to move the tape from one side or the other.

Poor maintenance and lubrication or worn tape tend to accentuate movements during the workout.

Replacement controller MA 500 with Endex controller


Controller MA500


Connectors
2 pin connector = speed sensor - sensor 2 pin speed
7 pin connector JA = console data - to console
M- = faston connector to the black motor cable 
M + = faston connector to the red  motor cable 
faston connectors AC = Connection line input 220VAC

optionals
faston inclination connectors UP / DOWN / COM = inclination motor connection 
3 pin data connector = inclination motor encoder 
5 pin data connector = data for inclination console
Replacement board for MA 500

2 pin connector = speed sensor - 2 pin speed sensor 

7 pin connector = console data  - to console = corresponds to conn. JA

M- = faston connector to the black motor cable 
M + = faston connector to the red motor cable
faston connectors AC line input connection = 220VAC (ACN = neutral ACL = line)

optionals
faston connectors tilt UP / DOWN / COM = inclination motor connection 

3 pin data connector = inclination motor encoder 
5 pin data connector = data for inclination console

horizon treadmill motor control board and others http://www.partsfortreadmill.com/index.php/parts-for-treadmill/treadmill-controllers-110-120-vac-input/