Saturday 28 June 2014

TREADMILL BELT ALIGNMENT

Contact us if your belt doesn't line up and must be replaced, or if you need spare parts

1. Under the deck, welded on the frame there are two guides.


2. Temporarily fold the belt under the guide.

3.  Measure the distance between the deck to the guide: this should be between 17 and 18 mm.



4. If the distance is different from that specified, use a wrench (10 mm) or another tool to restore the correct distance.

5. Be extremely careful to do it exactly on the point shown in the figure to avoid damage to the guide.

6. Repeat the same operation on the other guide.

7. Make sure the belt is even and tight, following the instructions on our blog.



No comments:

Post a Comment