Treadmill repair | Error codes and solutions E1 treadmill error in communication

Wednesday, 30 April 2014

Treadmill repair | Error codes and solutions E1 treadmill error in communication

E1: communication fail, digital communication from console to PCB failure

PROBLEM	SOLUTION
1.connect wire from meter to PCB broken	1.change the connect wire
2.meter cable head or PCB cable head or their pins not good.	2.check the cable head carefully
3. controller components broken	3.change controller

Please note E1 is usually a speed sensor error but on some treadmill boards is a communication error.

No comments:

Post a Comment

Warning - Legal Disclaimer

All information in this blog is directed to professional technicians.

We take no responsibility for personal injury or damage sustained by, or through the use of your treadmill or maintenance operations

To prevent electrical shock, be certain the treadmill is turned off and unplugged before cleaning and maintenance.

We have made every attempt to ensure the accuracy and reliability of the information provided on this website. However, the information is provided "as is" without warranty of any kind. We do not accept any responsibility or liability for the accuracy, content, completeness, legality, or reliability of the information contained on this website.

No warranties, promises and/or representations of any kind, expressed or implied, are given as to the nature, standard, accuracy or otherwise of the information provided in this website nor to the suitability or otherwise of the information to your particular circumstances.

We shall not be liable for any loss or damage of whatever nature (direct, indirect, consequential, or other) whether arising in contract, tort or otherwise, which may arise as a result of your use of (or inability to use) this website, or from your use of (or failure to use) the information on this site.