Wednesday, 30 April 2014

eway treadmill controller fault codes | treadmill controller led indications

POWER: Input power indicator light.

M-D: When power on, M-D indicator lights on for 3-5 seconds, then lights off. The M-D doesn’t light continuously when treadmill in use. If continue lightening, it means MOS(FET2,FET1) broken, so replace controller board.

LIMIT: If over currency or resistance force too big, LIMIT lights on, and machine stops automatically.

S-D: S-D light on will cause machine stop. Can turn on the input power and restart treadmill. If PCB S-D lights on continue, it means PCB short circuit.

UP: Incline up light. If doesn't light, function don't work.

DOWM: Incline down light. If doesn't light, function don't work.

PWM: PWM signal from meter (console) to PCB, the PWM lights when speed up. If this light is on but machine does not work, check motor wire or change PCB




No comments:

Post a comment