E1: when the E1
message appears on the console after about 5-10
seconds, it means that no speed signal has
been detected.
Solutions to the
problem:
• check that
the speed sensor is correctly connected to the control
board;
• check the
presence of the magnet on the front roller pulley;
• check that
the sensor cable is not damaged or there is no damage to the sensor
itself;
• check the
distance L = about 3mm (see picture)
of the sensor from the magnet on the front roller pulley; if
sensor iss too far or too close to the
pulley may cause error;
• replace the
sensor;
• if
it still doesn’t work check control
board, motor, cabling and console.
Contact us for a
repair quote for your treadmill.
No comments:
Post a Comment