Sunday 18 May 2014

Endex, Power First, Lieo Treadmill Controller, Digital concept treadmill controllers errors | Treadmill errors E1, E4, E7

1.    Treadmill Error Code E1
Description: System is not receiving the feedback of speed

Solution 1: Check the speed sensor if it is damaged or well fixed; the speed sensor has to be fixed at where it closest to the magnet within 2=3mm.

Solution 2: Check the signal cable of speed sensor if it is well connected to the controller. To solve the problem, please reconnect the signal cable to the controller.

In case both solution fails, means there is a problem on the sensor (check this blog for more information or buy on our eshop the replacement treadmill speed sensor), on the treadmill motor and/or controller board, which may need to be replaced

2.    Treadmill Error Code E4

i.    Description: Heart rate is not read from the heart rate sensors
ii.    Solution 1: Please remove the safety key and attach it again to restart the treadmill.

Solution2: First make sure your hands are moist when you use the handpulse. Handpulse don't work properly with completely dry skin. If this keep not working properly, dry your hands and check the cables on the back of the console. Make sure all connectors at the back of console are properly connected and no wires are damaged.



Please contact us for replacement parts

3.    Error Code E6
i.    Description: Too much load on treadmill incline motor. The bearing of incline motor lack of lubrication.
ii.    Solution: Enter the engineering mode and check the ADC readout or check if wires are well connected.
Incline motor may need to be replaced. Contact us for more information.

4.    Error Code E7
i.    Description: Incline error(ADC readout off limit)
ii.    Solution: Enter the engineering mode and check the ADC readout or check if wires are well connected.
Incline motor may need to be replaced. Contact us for more information.

No comments:

Post a Comment