Controller Board removal and replacement | Strengthmaster treadmill service, Carl Lewis treadmill repair

Prerequisite: Motor Hood Removal (see this blog for more information)

A.    Make sure that the power cord is disconnected and remove all of the wires connected on the controller board.

Note: This will require that you remove the glue holding the wires and connectors in place. Be careful not to damage any of the wires or pull the wire from the connector.



B.    Once all of the wires are removed, raise the treadmill to folding position then loosen the 2 screws fastening controller board on bottom deck.

C.    Before putting the new controller in place, apply the white lubricant.
D.    Put the new controller board in position and while align the screws position with the hole in the frame. Tighten screws to fasten controller securely.
E.    Reconnect all the treadmill wire connectors.

Contact us for parts and visit www.partsfortreadmill.com