Following codes are based on 16004 treadmill but do apply also for other models.
Need replacement parts? Buy them here:
-
- Running/Walking Belt for treadmill
- Treadmill safety key
- Treadmill drive belt (J6)
- Speed sensor for treadmill
- Treadmill running deck
- Treadmill controller 220 to 240 VAC input (Europe / Asia / Australia)
- Treadmill controllers 110-120 VAC input (North America)
- Treadmill motor
- Treadmill motor parts, brushes, holders, fans
- Transformers, chokes, breakers, cables
Error message E 03, so what to check
ReplyDeleteIt is an error usually related to speed (sensor/motor/controller). It is different if it starts and then stops with E3, or if it doesn't start at all and shows E3. I'd suggest you to contact a specialist, you can find a list here http://www.partsfortreadmill.com/treadmill-repairs
DeleteYes start little bit then they show error 3
DeleteIt is likely to be a speed sensor problem you can try to replace the speed sensor, it may solve the problem. You can buy the speed sensor here: speed sensors for treadmills
DeleteI tried to fix my belt tighten it since it was a bit loose, but something went wrong and now I have an E 02 error. What can I do
ReplyDeleteMy OMA 1600EA treadmill has on screen E 02. Please advice me
ReplyDeleteDoes it start and then stops with E02 or doesn't it start at all? If it doesn't start you should replace the controller. You can find the replacement here: https://www.partsfortreadmill.com/parts-for-treadmill/treadmill-controllers/
DeleteWhat if it starts and stops after 5 seconds.. ER 02
ReplyDeleteAdvice me, please
The motor wire does not contact well with the control board, check and connect again.
DeleteThe motor wire does not contact well with the control board, check and connect again.
DeleteTry to replace the speed sensor https://www.partsfortreadmill.com/parts-for-treadmill/speed-sensor-for-treadmill/
DeleteOur OMA treadmill not starting, please send service contact
ReplyDeleteHere it is: https://www.partsfortreadmill.com/treadmill-repairs
DeleteI have an error 5 ! It is fairly new ! What do I need to do to get it to work
ReplyDelete