Monday, 7 October 2013

Treadmill errors e0 e1 e3


Buy treadmill controller and treadmill speed sensor on our eshop.

PCB ERROR CODE AND SOLUTION
ERROR CODE
PROBLEM
SOLUTION
E0 
1. no safety key
1. connect safety key
2. safety key sensor broken
2. open the console case, replace the sensor under the safety key (use one of these sensors).
3. safety key does not work.
3. replace the key.
E1


1. motor does not work


1.change or rework the treadmill motor
2. speed sensor does not work
2. change or rework the speed sensor
3. roller magnetic not work
3. change or rework the roller
4. connect wire not work
4. change or rework the wire
E3:Only caused when use 'MODE' key
1. motor speed can not be control
1. change motor
2. motor not work
2. change motor
3. speed sensor not work well, no signal.
3. change speed sensor
Posted by at
Labels:

4 comments:

  1. Unknown11 April 2020 at 19:15

    mas mau tanya knp di tredmil saya pas tekan tombol star tiba2 berapa detik kemudian berhenti dan muncul E03 dilayarnya dan gmn cara menormalkan kembali biar bisa lancar lagi

    ReplyDelete
  2. Unknown11 April 2020 at 19:16

    mas mau tanya knp di tredmil saya pas tekan tombol star tiba2 berapa detik kemudian berhenti dan muncul E03 dilayarnya dan gmn cara menormalkan kembali biar bisa lancar lagi

    ReplyDelete
  3. Unknown21 August 2020 at 01:22

    I Turn on the treadmill , motor running a few seconds then stop and console board shows E03,
    speed sensor is good I checked
    board control I checked all component circuit is good
    can help me
    thanks

    ReplyDelete
    Replies
    1. Parts for Treadmill21 August 2020 at 09:20

      It looks related to the sensor, so if you are sure that the sensor is fine, please look at its position and if magnetic, if you still have the magnet on the roller. Also please check the cables, if one cable is pinched, it may block the signal from the sensor to reach the console.

      Delete

Subscribe to: Post Comments (Atom)