York treadmill E1 trouble shooting

York treadmill E1 flowchart

Contact us for any information and buy on our eShop York treadmill parts.

Astar 101 | AsTek TD700 | AsTek TD800 | AsTek TD1600 | AsTek TD1800 | AsTek TD1400 | AsTek TD350 | AsTek TD550

Astek treadmill controllers have been used on many different treadmills manufacturers,if you need replacement, buy on our eShop treadmill controllers or contact us for any information

Torque setup

Please turn clockwise or counterclockwise for half scale every time to get higher or less torque.

Alatech treadmill controller 6690 error codes | Alatech treadmill controller connections

Error messages on Alatech treadmill controllers

8.1『Treadmill error E01』：SPEED SIGNAL IS MISSING
8.2『Treadmill error E02』：OVER VOLTAGE PROTECTION
8.3『Treadmill error E03』：OVER CURRENT IS MUCH MORE 5 SECONDS
8.4『Treadmill error E04』：MOTOR PROBLEMS
8.5『Treadmill error E06』：COMMUNICATION FAILURE
8.6『Treadmill error E09』：INCLINE CHECKING PROBLEMS
8.6『Treadmill error E0P』：SPEED CHECKING PROBLEMS
8.7『Treadmill error E0C』：SHORT-CIRCUIT PROTECTION
8.8『Treadmill error E0E』： EEPROM  IS DAMAGED

Alatech treadmill controller connections

Available treadmill controllers? Buy it here:

1. Alatech

1. Treadmill controller 220 to 240 VAC input (Europe / Asia / Australia)
2. Treadmill controllers 110-120 VAC input (North America)  
3. Other fitness equipment parts

PMDC Motor for treadmill

PMDC stands for Permanent Magnet Direct Current Motor. This is the most common type of motor used on home use treadmills.

Buy on our eshop convenient Permanent Magnet Direct Current Motor for treadmills

Running belt | how to replace and how much walking belts cost

1. Motor Hood removal and replacement

2. End Cap and Side Rail removal and replacement

3. Rear Roller removal

4. Front Roller removal
Before beginning, mark the position of the Belt Tension Bolt. You can do this by counting the number of threads on the tension bolt or noting the location relative to the round hole on the side of the mounting bracket.

 5. Deck removal

Replacement Steps: A. Use a silicon lubricating spray on the inside of the belt before installation. B. Place the new belt inside the treadmill frame as shown in the picture to the right.
Don't forget to tension and center the walking belt.

Buy high quality, brand new running belts from 65£ 
Buy european quality treadmill running decks from 49£

Endex DCMD67, DCMD57, DCMD77

 

Endex DCMD67M WITH INCLINE(BOARD AVAILABLE ALSO WITHOUT INCLINE)

 

ENDEX DCMD77

DCMD67. DCMD57, DCMD77 board layout

Differences between DCMD67 and DCMD57

DCMD57

All boards DCMD77, DCMD67M may be replaced by DCMD57. Please note that DCMD57 is always with incline, while DCMD67 is available with and w/o incline function.
Buy on our eshop treadmill controllers.

Endex treadmill controllers Replacement | Wiring diagram

 

Need a replacement controller? Buy it here

 Endex treadmill controllers

Other brands controllers

Need other parts? Contact us or visit www.partsfortreadmill.com