Over time
the walking belt may become misaligned. You can center the belt by using an
allen wrench.
Only use
the left side idler bolt. If the belt is too far to the left, turn the wrench
to the right or clockwise. If the belt is too far to the right, turn the wrench
to the left or counterclockwise.
With the
belt stopped turn the idler bolt in 1/2 turn increments followed by 1/4 turns
for finer adjustments. Then start the walking belt and the belt should adjust,
repeat these steps until the belt is centered.
You can
buy a good quality low friction replacement belt here: https://www.partsfortreadmill.com/parts-for-treadmill/belt-for-treadmill/
No comments:
Post a Comment