Connecting a treadmill motor control board (Endex)

Tuesday 21 October 2014

Connecting a treadmill motor control board (Endex)

The signal cables are all different from each other and cannot be mistaken, it is the faston cables that require more attention

M+ connect to the main red motor
M- connect to the main black motor
ACL / ACN connect to the input of the alternating current network

And the three incline motor fastons
white COM
red UP
black DOWN

1 comment:

Unknown18 December 2014 at 06:49
hello
dear
this
control board
how
universal
can be used?
I control board
How to give a signal,
ReplyDelete
Replies

Add comment

Warning - Legal Disclaimer

All information in this blog is directed to professional technicians.

We take no responsibility for personal injury or damage sustained by, or through the use of your treadmill or maintenance operations

To prevent electrical shock, be certain the treadmill is turned off and unplugged before cleaning and maintenance.

We have made every attempt to ensure the accuracy and reliability of the information provided on this website. However, the information is provided "as is" without warranty of any kind. We do not accept any responsibility or liability for the accuracy, content, completeness, legality, or reliability of the information contained on this website.

No warranties, promises and/or representations of any kind, expressed or implied, are given as to the nature, standard, accuracy or otherwise of the information provided in this website nor to the suitability or otherwise of the information to your particular circumstances.

We shall not be liable for any loss or damage of whatever nature (direct, indirect, consequential, or other) whether arising in contract, tort or otherwise, which may arise as a result of your use of (or inability to use) this website, or from your use of (or failure to use) the information on this site.