Procedure:
i. When the console is at standby status, press “ENTER” and “INCLINE ︿” (or hold “SPEED ︿” and turn on the machine) to enter the Engineering
Mode.
ii. Console scan mode goes on(all digits go flashing and off ).
iii. Press “ENTER” to switch the scan mode(Data Line).
iv. Press “ENTER” to switch the scan mode(Scan Line).
v. Press “ENTER” to switch the scanning of a single LED.
vi. Press “ENTER” to switch the scanning of the decimal point.
vii. Press “ENTER” and the Dot Matrix Window shows “KEY”, the Alpha Numeric Window shows “KEY VALUE=” and then it enters keyboard test mode.
viii. Press “ENTER”, the Alpha Numeric Window shows “ATUO TUNING” and then it enters automatic tuning function.((((Only for AC motor))))
ix. Press “START” and “SPEED ︿” to start, the Alpha Numeric Window shows “PLEASE WAIT”. Time starts to count and it stops after a 25-second counting, then the window shows “TUNING OK” (Note: Do not step on the running belt when the Automatic Tuning is on).
x. Press “ENTER” , the Dot Matrix Window shows “IO” and it enters IO test mode.
xi. Press “ENTER” to control the relay switch; press “INCLINE ︿” to incline up; press “INCLINE ﹀” to incline down; press “SPEED ︿” to speed up; press “SPEED ﹀” to speed down; the Heart Rate Window shows heart rate; the Incline Window shows ADC value and the SPEED Window shows
feedback of speed.
xii. Press “ENTER” to test again or press “ENTER” and “INCLINE ︿” to return to the standby status.
Buy Endex controllers on our eshop
No comments:
Post a Comment