Saturday 15 February 2014

Treadmill Engineering Mode & Test Mode

Following information is valid for most of treadmills equipped with Endex Controllers

There are two different modes of operations built into the console which are useful for getting information and testing certain functions of the treadmill.

The different modes are:
1.    Engineering Mode:
This mode goes through what software version is being used on the treadmill, the software parameters, the ability to change between Metric and English units, the total mileage on the treadmill and the total number of hours the treadmill has been used.

2.    Test Mode:
This mode takes you through several different functionality checks for the console and a quick check on the MCB Start Relay Switch. This allows you to see all the readouts on the console, checks all the buttons functionality, checks for incline functionality and Test/Calibration and checks to make sure the MCB is capable of driving the running belt.


No comments:

Post a Comment