You can
find replacement running belts, drive belts decks and isolators on our website
http://www.partsfortredmill.com
Remove
the motor hood and place the walking deck into the storage position. If there
is a storage latch make certain that the storage latch is properly secured. Locate
and remove the screws from the underside of the walking platform to remove the
sidederails. Your treadmill most likely has 8. Refer to your users manual for
verification. Siderails may be also sticked with double sided tape or fixed in
different ways. Carefully lower the walking deck and remove the side rails. Remove
the back idler bolts. Remove the back idler roller.
While
turning the drive roller by hand pull on
the inside of the drive belt in order to walk it off.
Mark the
exact position of the front roller if you need to unscrew any screw there. Then
remove front roller. Sometimes it is not needed to remove the front roller as
the belt can slide on the open side.
Remove
the four screws found above each of the isolators using an allen wrench. Remove
the four bolts found in each corner of the walking board. You will also need a
crescent wrench.
With two
people lift the walking board up and remove the running belt and the running
board. Replace the walking belt. Using your allen wrench replace the bolts in
each of the four
corners
of the walking board. Screw the isolator screws back into place, slide the
drive roller into place. Then walk the belt onto the pulley just as it was
taken off, replace the idler roller,
screw the
idler bolts back in and screw the side rails back on. Now put the motor hood
back on. Please refer to our videos aligning the walking belt and tensioning
the walking belt for any help needed while adjusting the walking belt.
No comments:
Post a Comment