Correct
lubrication of the running belt allows friction to be limited and
helps to prolong the service life of the motor and of the motor
control board. It is therefore a fundamental maintenance operation to
ensure the long life of the treadmill.
For
the lubrication of your treadmill we suggest you use only 100%
silicone sprays and avoid sprays that use additives and petroleum
distillates, which could ruin the running belt or the deck.
The belt and the deck surface must be slightly
greased. If the surface is dry, proceed with lubrication by following
one of the alternatives presented below
Alternative
1
1)
close the treadmill in a vertical position
2)
spray 3 or 4 times with the lubricant under the belt
3)
reopen the treadmill, start it at low speed (4km / h) and walk for a
few minutes
4)
check that the lubricant is spread over the entire surface
Alternative
2
1)
lift up the running belt
2)
using a straw, spray the lubricant as much as possible towards the
center of the running deck
3)
start the treadmill at low speed (4km / h) and walk for a few minutes
4)
check that the lubricant is spread over the entire surface
Caution:
1)
it is important to avoid too much lubrication of the treadmill
(wetting the belt).
2)
try to always lubricate well the center of the deck (where you
normally walk)
3)
always lubricate the lower surface of the belt (between the deck and
the belt, normally colored in white). NEVER lubricate the top surface
of the belt (black) to avoid making it slippery.
No comments:
Post a Comment