Universal treadmill board and console kit to be used with 8 to 9 cm diameter DC motors

Universal kit, which includes a board and a console for treadmill. To be used with 8 to 9 diameter DC 180-230V motors.
Please note:
If your treadmill has manual tilt or your inclination motor doesn’t have position encoder, please contact us.
Functioning of the universal replacement kits and treadmill consoles
This kit is made up of:
Console with LCD backlight;
Display: 109 x 44 mm LCD,
Speed range 0.8 ~ 14 km / h
Motor controller board capable of driving engines up to 9 cm in diameter
Security key
Magnetic sensor kit + magnet to be placed on the treadmill roller to read the speed
Console Features
     Security key
     Provides reading of BMI (body mass index) and body fat
     Gradient control: engine inclination on 12 levels
     Programs: 1 manual, 7 pre-set programs, 3 targets, 2 HRCs and 2 user-set programs
     Easy control of speed, tilt and start / stop
     Predisposition for heartbeat control (via hand pulse or chest-belt by means of a special adapter)
Installation
Install the wiring of the new kit, possibly drilling the original console plastic
     Remove the original controller of the treadmill, including any transformers connected to it. You no longer need any transformer because the new controller is self-powered.
     Put the new engine card in the place of the old one, and then reconnect the cables
      Connect speed sensor 2 pins If the old board did not have speed sensor -> install the 2 pins sensor provided in the kit on the roller
If the old board had a 3 or 4 pins sensor -> remove the old sensor and install the 2 pins sensor provided in the kit on the roller
Connect 3 pins inclination sensor
         Connect Console data cable: 4 pins
       Connect Main motor cables: two faston connectors, M + (red) and M- (black)
       Connect Inclination Motor power cables: Three Faston Connectors, White COM - Red UP - Black DOWN
Connect AC power cables (place on AC connectors).
     Connect the console cables, in particular the motor-console data cable and any other connectors (handpulse, additional keyboards), as shown in the attached scheme
     Now paste the new console, using the two-sided tape supplied with the kit.
Check the console manual to see all functions: download the manual here
Universal treadmill board and console kit to be used with 8 to 9 cm diameter DC motors.

 https://www.partsfortreadmill.com/index.php/universal-controller-board-treadmill-8-9-cm.html