Adjust treadmill motor controller board after motor change

Sunday 10 November 2013

Adjust treadmill motor controller board after motor change | Astek treadmill boards

1. Please adjust the IR, LIMIT and SPEED value on the MCB.

2. For Turdan Motors, adjust the IR value to 11 and LIMIT value to 5.5

3. For Turdan Motors, adjust the SPEED value to 8.5

No comments:

Post a Comment

Warning - Legal Disclaimer

All information in this blog is directed to professional technicians.

We take no responsibility for personal injury or damage sustained by, or through the use of your treadmill or maintenance operations

To prevent electrical shock, be certain the treadmill is turned off and unplugged before cleaning and maintenance.

We have made every attempt to ensure the accuracy and reliability of the information provided on this website. However, the information is provided "as is" without warranty of any kind. We do not accept any responsibility or liability for the accuracy, content, completeness, legality, or reliability of the information contained on this website.

No warranties, promises and/or representations of any kind, expressed or implied, are given as to the nature, standard, accuracy or otherwise of the information provided in this website nor to the suitability or otherwise of the information to your particular circumstances.

We shall not be liable for any loss or damage of whatever nature (direct, indirect, consequential, or other) whether arising in contract, tort or otherwise, which may arise as a result of your use of (or inability to use) this website, or from your use of (or failure to use) the information on this site.