TILT RECALIBRATION
PROCEDURE
This
procedure is to calibrate incline motor on the ZY02V1.1 (DIP)
card. Calibration must be performed each time the card is replaced in order to restore the
parameters of the minimum and maximum elevation motor. Otherwise the motor elevation forces
itself too much and burns.
1) remove the safety key
2) press and hold the button on the motor board, turning on the master switch
3) Press and hold the button until the console does not beep
4) Release the button and wait for it to finish (the carpet goes up and down by
itself)
5) Put the safety key back in and test the elevation. If you still feel it
forces itself, repeat the operation
Caution:
DO NOT stand on the carpet during the recalibration
Contact
us or visit our eshop to repair or buy treadmill motor boards - tec@partsfortreadmill.com
No comments:
Post a Comment