Sunday 3 November 2013

Treadmill E1 error | change the optical speed sensor to a magnetic speed sensor without replacing the original power board

In case you need to change the optical speed sensor to a  magnetic speed sensor without
replacing the original power board please do the following:

1) Fix the magnetic speed sensor to the correct place pointing towards the magnet
in the front roller. Leave the distance between sensor and magnet 2 - 3 mm

2) a. Connect the speed sensor to the power board by using the 2 pin cable: 

    b. or cut original wires, and connect wires directly. Red is not connected. (close up open 
        wires with shrink-hose)
    c. or connect the 2 pin plug directly on the 3 pin socket on PCB. Right 2 pins are used. Left      
        one is not connected. Pls make sure connector is fixed properly to the socket (glue).

Please connect the power and manually rotate the front roller to see if the speed signal appears
on the power board on LED in position D30

No comments:

Post a Comment